BleedCheck

Print-shop card specs, checked against the shop's own pages.

Your art never leaves this browser.

How to print duplex card backs at home

For print-and-play and playtest decks: print the card fronts and one shared back double-sided, so every back lands behind its card. Most of the work is three settings and one test sheet.

Printer settings that matter

Scale100%, "Actual size" or "None". Never "Fit to page", "Shrink oversized pages" or "Scale to fit": they resize the fronts and backs differently, and the cards come out the wrong size.
Two-sidedOn, using the same flip edge you chose in BleedCheck (long edge or short edge)
PaperThe same paper size as the PDF (Letter or A4), fed the same way for every run
Auto-rotate / centreOff if your print dialog has it. The PDF already puts each page the right way round.

Step by step

  1. Build crop-mark sheets. In BleedCheck, add your card faces, pick the shop and size, then under Print-ready PDF choose "Crop-mark sheets" and your paper.
  2. Add the card back. Press "Add card back…" and pick one image. A back page then follows every front page, mirrored so each back sits behind its own card.
  3. Choose the flip edge. Use "Long edge" unless your printer only flips on the short edge. What matters is that the printer dialog uses the same edge.
  4. Print the alignment test. Press "Alignment test" and print both pages double-sided on plain paper, at 100%.
  5. Read the offset. Hold the sheet up to a light, back side facing you. Each front cross shows through next to a millimetre scale. Read where the cross's vertical line meets the horizontal scale (right is +) and where its horizontal line meets the vertical scale (up is +).
  6. Enter it as the back offset. Type those two numbers into "Back offset: Right / Up". BleedCheck moves the back pages, crop marks included, and remembers the values on this device.
  7. Check, then print the deck. Print the test again: a fixed printer reads 0 on both scales. Then download the PDF and print the real sheets.
Make your duplex card sheets

Common problems

  • Backs upside down on every other card, or the whole page: the printer flipped on the other edge. Switch the flip edge in BleedCheck or in the print dialog so the two match.
  • Cards a few percent too small and the misalignment gets worse towards the edges: the page was scaled. Print at 100% / actual size.
  • The offset changes from sheet to sheet: the paper is slipping in the tray. Load less paper, square the stack and use the paper guides. One number can only fix a steady shift.
  • More than 5 mm out: BleedCheck stops at ±5 mm, because a shift that big means a scaling, paper-size or tray problem rather than normal printer drift. Fix that first.
  • A thin edge of the back shows on the front: add bleed to the back art, or use a back with a plain border so small shifts don't show.

Every home printer shifts the back side a little. Measure yours and expect it to change with a different printer, tray or paper weight. BleedCheck is free, runs in your browser and is for original games only. Ordering from a print shop instead? See How to make a DriveThruCards PDF.

Reading the alignment test from the back: the front cross shows through 2 mm right and 1 mm down, so enter Right 2, Up -1 +5 -5 +5 -5 Seen from the back Right +2 Up -1 black: back scale (1 mm ticks) pink: front cross, through the paper